Question:
How do I properly mix Jintropin?
Answer:
Using insulin syringes (the smallest) with unit marks on the side. Break the neck of the included 1ml water vial, stick the insulin syringe in, pull the water out (it should all fit in the syringe since it’s 1ml). Break the plastic cap off off the Jintropin vial, clean the rubber with alcohol then stick the needle trough it.
DO NOT INJECT STRAIGHT INTO THE POWDER WITH FORCE, doing so might damage the cells. You need to let the water gently slide down the side of the vial. After you are done injecting, pull the needle out and put the safety cap on (so you don’t contaminate it). Take the vial and gently swirl it in your hand. Do this for a few minutes untill all the white powder has all disolved. Pull air into the insulin syringe and inject it into the vial to release the vacum. Don’t inject air into the HGH mixture itself, you don’t want bubbles in it. Keep the needle in the vial and turn it around so the vial is up and syringe is down. Slowly pull the entire content of the vial into the syringe and there you have it.